I wanted a way to insure that the relative position of the XTool D1 Pro and the XTool Honeycomb I am using with it are always in the same position.

The holes are sized to slip fit the risers I made to compensate for the thickness of the Honeycomb.

To install you must put the risers in each Holder first, then slide the back into position and ten lower the front legs onto the risers. It is a very tight fit, it is supposed to be.

You will need to print 4 of the Short Leg Risers. Print them small end down and you won't need any supports.

Print 2 each of the Honeycomb Holders. Each one will need to be flipped to eliminate the need for supports.

I just added a variation of the design that can be cut by the XTool D1 using Lightburn.

Bambulabs

Bambu X1C

No

No

I used 50% but I don't know if it is really necessary.

The "L" jig was cut after everything was installed and a 12 inch square of plywood was screwed down along the back edge and the left side. I then cut a 12 inch square with the upper left corner at position X = 20 and Y = 20. That left the "L" jig.

To use the "L" Jig position your project with the left top corner at the X = 20 and Y = 20 position and you will always have your project exactly where you want it and it will always be square.

One other note: If your are going to be cutting out the project you should position at position X = 25 & Y = 25. If you don't you will cut into your "L" jig and have to redo it.

I learned that the hard way.