Make perfect snowmen even with powder snow!

Unlike typical snowman molds that only work with wet, packable snow, this mold is designed to work with any snow condition - including dry powder.

How to use

If you're working with powder snow, you have to pack a lot of it in there by compressing it, then adding more. Use as much force as you can, the mold can handle it. The snowmen release better when the mold is cold and dry. If your snow is really wet, it can't be compressed. Manually filling each half perfectly to the brim is not feasible, so you're better off overfilling it and cutting off the excess.

Powder snow

1. Fill both halves of the mold with as much snow as you can

2. Press them firmly against each other

3. Release the snowman by squeezing each half (use the grip tabs on the sides)

4. Repeat steps 1-3

Wet snow

1. Slightly overfill both halves of the mold with snow

2. Slide them onto each other from the side, using the edges of the mold to cut off the excess snow

3. Push both halves firmly together

4. Release the snowman by squeezing each half (use the grip tabs on the sides)

5. Repeat steps 1-4

Printing

No extra settings required, just hit print. Use the included print profile. PETG works great!

I print mine with the default 0.2mm QUALITY preset.

Note: if you're having bed adhesion issues on your printer, consider enabling the brim function for this print.