This is a wall mount for the Nokia Home camera / baby monitor (https://health.nokia.com/nz/en/home). While it comes with a nice magnetic tray to sit in, my wife and I wanted to have ours up and out of the way. This mount is meant to go in the corner of a room.

You’ll need to print 2 of the brackets and one of the base. The brackets should just slide onto the base. To mount this to the wall, I used command hook strips so it’s easy to put up, and easy to take down (it slides off the brackets so it’s easy to pull the tabs to take it off the wall). For me it was easier to put the tabs on first and then stick it to the wall all in one piece, rather than try to mount the brackets first.

Print instructions

Licence: Creative Commons - Attribution Category: Camera Print Settings

Printer Brand: Prusa

Printer: Prusa Clone

Rafts: No

Supports: Doesn't Matter

Resolution: .2

Infill: 20%