General

I wanted to get my JBL Link 20 off the floor since there's no table or anything near where I plug it in. The thing with the Link 20 is that it's quite big and heavy and applying too much weight on the socket could degrade it quickly (not to mention my plug is a bit loose and probably should update it😅). Hence, this design which relieves some of the stress from the socket and applies it against the wall.

Print Settings

✔️Skirt

❌Brim

❌Supports

I printed this on PLA with a 0.6mm nozzle at 0.48mm layer height. Layer height probably doesn't matter so much and you can probably even go with a 0.8mm. The design is fairly forgiving.