I found that using my switch in handheld mode i would rest my hands on myself and have to look down far enough that i was experiencing neck pain. I created this model after finding that people were using tablet holders that were similar to this, but they looked flimsy and also costed money. Naturally i figured i could print something more personalized so i did. 

I orginally planned on using the thumb screws to take this on and off but i found out that the upright mounts that hold the switch flex enough where i can take it on and off without undoing the screws even with having quite a large head. (No joke, size 3XL helmets).

The neck fits comfortably around the back of my neck with a 6" ID. I would print the neck piece first to make sure it fits, then proceed to print the rest of it.

The screen sits between 10" and 12" away from my face which i havent had a problem with. At this point ive used it probably about 3 hours non-continuous only being pulled away cause of fatherly duties. Not because of neck strain or eye strain.

The neck piece, the lower part of the connecting arms and the switch holder all get threaded inserts and its all put together with M4 bolts. 10 inserts and 10 bolts.

I printed everything with 3 walls, 20% infill

Sorry but nothing is oriented correctly so youll have to do that when you slice

Source file is included for remixes or incase you just want to check it out. 

Thank You for checking out My Model!