Remixed a remix to allow me to use larger spools. This one allows me to hold 3.5KG Spools. I love the design where it attaches and holds onto the control unit with the original screw pattern. I just took this and modified it greatly to hold bigger spools.

Final Pictures of the setup coming soon.

Notes:

• TAB File allows the unscrewed holder to stay centered on the control panel.
• The Screw holder locks down and makes sure the entire unit doesn't move completely off the control box while printing.
• The distance from the center of the roller bearing mounts is 177mm, use this as a reference to see how small of a spool will fit.
• Uses regular 608 Bearings.
• You will need to print one of the Screw mount side and 3 of which ever free side you'd like. Tabs or Tab-less.
• Supports only needed on the screw side part.

If you like the design, feel free to send a tip using Crypto's!
Bitcoin Tip Address : 1FEMcSdY19L1BNiLzkfc8eySGdrhqyf4Pu
BitcoinCash Tip Address : 1A4cUAZa23mg95REeUQLhac8wDDJcGvaBb
Litecoin Tip Address : LLsy8pfTRThVpQmsjUTMtJmsGrcpqFdNYd
Ethereum Tip Address : 0x6814b3584bef4bb2bbf8250fb93dfcff36036c10