Hola Amigos!

i just got fresh into the 3d printer space with my ender 3 s1. After searching for a can organizer that does not connect the upper and lower lane to store two different types of cans I found myself the first time in fusion trying to make that thing work. We usually dont have too many cans of one kind so therefore I needed just a separation.

Dont want to get out all 4 cans of tomatoes to get to the chickpeas one :D

The most issues I had was designing the connectors in the middle to keep the left and right part in place. Just couldnt get the spacing right so they would grab onto the rails and not bend too much because of the mounting pressure. 

 Our cans are usually 110mm high with a 72mm diameter. Cans in that height should fit in there: 105 - 115 mm 

Cans with a diameter up to 75 (maybe 78 mm) should fit. A little tricky to test since the front exit of the lower row is a little limited by the lip of the upper rails. It latches onto the can and prevents too big cans to go in but also holds installed cans nice in place