I needed a holder for my cutting boards so they didn't have to stay in the cupboard.

We have an old house so this is very helpful.

I designed this in Tinkercad.

I have uploaded a new version of the cutting board holder, it has smoother edges and countersunk holes for the screws.  This one was designed in Fusion 360.

Print instructions

It is easy to print and does not need any support. It prints in 2 hrs 30 mins with 25% infill. Printed in PLA.

You can print it with any infill and filament that you like.

V1 - You will two or three 5mm screws.

V2 - Only need two 5mm counter sunk screws.