Grey/Orange was the only Scuf Instinct Pro controller available when I ordered mine. I really don't like the orange rings so I ran this through a few iterations and ended up with these replacements that I'm happy with.

I printed the first version on an FDM machine (Ender 3) and I wasn't happy with the quality compared to the resin. With tuning/good settings, these can be printed FDM and achieve acceptable results. I found it most important that the face of the rings looks good, as the rear spines are pretty forgiving of imperfections when snapping in place on the faceplate.

Elegoo Saturn

No

No

3840x2400

Printed using stock settings on Elegoo Saturn. Sliced with Chitubox, no supports, no raft, prints in 19 minutes. Anycubic 405nm resin. Rinsed with 90% alcohol and cured in Elegoo Mercury.