Heavy case for my 2.5" HHD

Minimal printer size : 50x90x120mm
Estimated time : 7h

No brim or raft needed

Bill of material

• 4 M3*18 screw with nuts
• Protection foam or thin rubber
• SATA to USB adapter
  https://www.aliexpress.com/item/SATA-Cable-Converter-USB-3-0-Cables-22-Pin-SATA-Hard-Drive-Adapter-Laptop-2-5/32998925790.html?spm=2114.search0604.3.7.3efd7a5718cWvx&ws_ab_test=searchweb0_0,searchweb201602_5_10065_10068_319_10892_317_10696_10084_453_454_10083_10618_10304_10307_10820_10821_537_10302_536_10843_10059_10884_10887_321_322_10103,searchweb201603_52,ppcSwitch_0&algo_expid=30bd26f7-abef-4803-a4c4-8b6a51e1c138-1&algo_pvid=30bd26f7-abef-4803-a4c4-8b6a51e1c138
  or
  https://www.ebay.de/itm/USB-3-0-SATA-to-USB-2-0-Adapter-Cable-USB-2-0-TO-USB-3-0-SATA-7-pin-connector/263976713478?hash=item3d763cfd06:g:k7wAAOSwIVVcahFv:rk:48:pf:0

Assembly

• First open the adapter and assemble the 2 small parts with 2 screws

• Add protection foam, rubber (<1mm thick) or thick tape around disk before mounting the last part.
  Be careful the the side. The disk may have a "Do not cover" hole. And do not cover it
  You may have to sand a little the 2 small parts (where there is the screw hole) if you have printed with support

• Assemble the third part and close the case with 2 screws

Sample print settings

Small parts :
Infill : 30%
Support density 10%
Speed : 60mm/s
Layer thickness : 0.2mm
Time needed : 2 * 1h30

Big part :
Infill : 20%
No supports (vertically printed, screw hole at the base)
Speed : 80mm/s
Layer thickness : Adaptative
Time needed : < 4h