Summary Let your opponent know who you are by proudly flying a Monogrammed version of the standard Seej Battle Flag. You will need this to play, I made a complete basic set in one file including my modified throwing arm - http://www.thingiverse.com/thing:127450 The flag is small so try to use under 6-8 letters. The letters will get too thin to print if you add too many. (see photos) Either use the web-based customizer or download the openSCAD file. Have Fun, and share picts of any flags you make. Instructions Each Seej Battle Flag will need one each: -your customized flag stl -flag post -flag off set base SPECIAL NOTE! about the setting for descending lowercase characters..(and some "normal" BlackRose characters that dip below the standard bottom of the line). Use this setting to move the text up if any letter bottoms are getting cut off..like descending lowercase letters(like y,g,p,etc), this setting will move the text up so they are not cut off. BUT if you do not have descending lower case letters then this setting will cut the tops off! Yikes! Since the letters make the flag heavier you should use the offset base included so it will not topple over due to the heavier flag.