This is a remix of the Drip Bed Attachment made by TexomaEV.

The original works perfectly, but I wanted a more secure version that fit more snuggly into the Z-arm and a bit thicker so you can print on regular PLA and not worry.

Also, I thought putting in the slit made it more aesthetically pleasing (plus adds to security)

UPDATE:
Added a drip bed attachment that leans the opposite direction.

SeeMeCNC

Rostock MAX v3

No

No

.3mm

20%

I tested this a few times and increased the tolerance to a pretty good level for all my FDM printers.

If still tight, I think you can sand a little and it should be good. I had to sand a little on the Carbon Fiber version, but it's also the smoother sliding in and out now.