A simple box to protect a DJI Mini 3 Pro with the new DJI RC controller.

The lids are to be printed in TPU, as the design is reliant on the flexibility and slight stretch of TPU. The other parts are to be printed in PLA.

The End Boxes are to hold the usual small trinkets that you need to carry, print 2 of them, one for each end. If you don't need these, put some packing in the main box in their place to give extra support to the upright walls in that area.

The controller tray has finger notches to allow for easy removal of the tray from the box. The End Boxes have notches to allow easy removal from the box - always place these in the main box with the notches facing the open part of the box.

There are also storage compartments that are along both sides of the drone, designed to hold unopened props and the supplied USB-C cable.

The controller tray has a small compartment in the middle which will hold a charging cable, but has no lid so is unsuited to small parts that may easily drop out.

ASX1

Doesn't Matter

No

0.2, or as preferred

10% or less, as preferred

Supports not needed, but enable bridging for the end boxes. If your slicer does not support bridging, consider supports on this part