This is The Flexy Slick Figure, or Flexyman for short. This is a stick figure that you can make out of silicone or TPU. It is fun to fidget and play with and has a simple look to it.

If you use the 3D printed mold box, you will need around 25 mL of your silicone solution to pour in. 15A is a good silicone thickness to make it springy, but if you prefer yours to be more limp and floppy, I would definitely use a softer silicone (I don't suggest using anything much harder than 15A. By that point the stick figure will become too stiff). I also recommend printing the two parts of the mold box vertically to get as much detail as possible (all the files should already be in the correct orientations for printing), and it still won't need any supports when printed like this. Make sure to also clamp the two parts of the mold box together before pouring the silicone.

For TPU, I am still experimenting. For this method, use the "TPU_Flexyman_V2" file. For what I have found so far, use TPU filament softer than 90A and use 2 wall loops with little or no infill (use gyroid infill pattern if you do have some infill). Supports will be needed right underneath the shoulders, and use a brim if you think your printer will need it.

Check the remixes tab to look at accessories for customizing your Flexy Stick Figure.

Check out the entire Flexyman collection here.