This is my attempt at modeling the Rasputin Warmind from Destiny 2. It's been a while since I've had to make a model from scratch, but this is where I think I'm going to call this one finished... mostly. I may come back and add more details later on.

This is intended to be approximately the size of a mid-tower computer case, as that is what I originally designed it for. I haven't added any internal mounting points for that yet, this is only an outer case/shell. The model is split into pieces based on how you want to assemble it, from the full model to a half, quarter and eighth. The 1/8 piece can be mirrored and duplicated (to a total of 8 parts) and assembled into the full model. This is designed for 3D printing, but you may have to orient the parts differently or slice them to fit your machine.

Please note: This is not a complete model of the Warmind. Rasputin has a lot of detailed structure built around him and many details that, based off images alone, I could not replicate here. The back side of the model is simply a mirror of the front due to the lack of images showing the back of the Warmind.

Also important to note; there is NO STAND for this model. I haven't figured out how I want to secure it on my desk yet, so it will not stand up properly on its own.

EDIT: I've cleaned up the model a bit and fixed some errors when scaled down. Anything from 100% to 25% of the original size should work normally. Below this scaling you may notice small gaps where parts of the model are too thin to be printed. This can be fixed by using a nozzle smaller than 0.4mm if you want to print it smaller than 25%.

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Filament: ~ PLA ~

Notes:

Design Process