An undershelf drawer to keep a tool handy. Could be mounted under a desk or table - or anything else you like. I mounted mine on a shelf.

Easy print, no supports. Use a brim if your prints tend to warp. I added a bit of friction tape to the inside slanted edge of the holder, slides better on the tape (I use hockey stick tape). I used 3 walls and 4 on bottom and top, 14% grid infill. Wanted it strong. I printed in PLA+ but any material should work, maybe not TPU.

I used #8 1" screws - #6 heads were too small for the holes.

This is the 200mm model - I made a longer one designed for my calipers - but tried to upload that file too but got a message about no more storage allowed. ???