I've been getting into string art suspension models lately and wanted to create something involving Skyrim things.  Following a tutorial on how to add the strings to a model, I did that inside of tinkercad and this is the final result. 

The .3mf file was saved with Prusaslicer and just has a modifier block to prevent supports on the stings and anything above them.  You could also just use the stl file and paint on supports to the bottom of the beacon and the top of the rock base. 

You MUST make sure your supports are properly calibrated to be able to easily remove them from the floating beacon without breaking the stings.  It took me a total of 3 prints until I finally got them calibrated to where I could pop off the beacon, then I had to chip away at the snug supports pulling them like ribbons.  I found it easy to use some cheap knockoff 3m tape to secure this to a table while removing the supports.  It's a challenge, but that's part of the reward.  I printed it in PLA, so any filament should work as long as you can print clean w/out stringing.