AMS Lite top-mounted rotating bracket. If you place the printer on a shelf like I do, this bracket allows the AMS Lite to be mounted on top and rotated, making it easier to load consumables. However, when rotating, it locks into place in the groove to prevent the AMS Lite from constantly spinning during printing. Use the existing AMS Lite screws to secure the AMS Lite to the bracket. You'll need 2 quarter-inch-20 screws and 2 quarter-inch-20 nuts. The screw length depends on the thickness of your

https://www.lowes.com/pd/Hillman-1-4-in-20-x-1-in-Allen-Drive-Cap-Screws-2-Count/50088912

The third board is a template, which you can print out to determine the location of the holes to be drilled in the bracket.

I created a PTFE pipe organizer to help prevent PTFE pipes from getting tangled when using this top-mounted AMS Lite or any other top-mounted modification.

https://makerworld.com/en/models/182985#profileId-201599

Once I mounted the AMS Lite on the ceiling, the cable was too short, so I ordered this one:

https://www.etsy.com/listing/1459330676/coupler-4-pin?ref=yr_purchases&variation0=3690686738

And an extra cable from Bambu:

https://us.store.bambulab.com/products/ams-lite-4-pin-cable