Remixed from Milkie to be a single low profile cable clip mostly for the rear triangle on the Evil Wreckoning to hold the brake line at the two clips.

Designed/Tested on a Wreckoning LB with stock Jagwire cable.

Can scale Z up to about 4-5mm for additional width if you like but it becomes more fragile and prone it cracking when installing.

Same directions as Milkie's version,

"When fitting, put both cables in the clip, fit the side without the bump first, then the other side. Be careful not to snap the clip when fitting, it is a tight fit so it doesn't move or rattle."

Voxelab Aquila

No

No

100%

I was able to print with no brim, print is small so decrease your print speed min. by 50% from normal aka around 15-20mm/s. I used 100% stock 4010 cooling fan as part is very small after layer 2
237C/85C bed
0.2mm layers
0.4mm line width w/ 2 walls