You can put like a student id or something in the back and then place your phone on top and it wont bulge and you can see it easily.

Special thanks to iLikeDarbo for the original case file!

p.s. the thing in the middle is the camera cover put it in with the wider side touching the camera. And when you are putting the case on bend the front part slide the top in then release, bend the bottom horizontally and it should fit. 🙂

Creality

Ender-3 V3 KE

Doesn't Matter

Yes

standard

standard

The supports are hard to remove I recommend using an exacto knife and needle nose pliers. I also recommend using normal supports instead of tree as the lip will be better if you use normal supports.