Created a USB Port Plug with a Removal Tool. This is to be used in Data Centers or equipment that is always on. It helps to keep the USB Ports clean of debris and dust. I have had multiple USB ports get shorted out. They were just dusty. So I created this. Cheap and efficient.

Updated the Removal tool to have a longer reach and I closed one side of the receiving insert so you don't slide off the USB Plug.

Creality

Ender-3 v2

Yes

0.2

100

When printing these smaller items I use KAIZUO Glue Sticks on the plate.

I print the Removal Tool with supports because of its shape. I usually start supports at about 50 degrees.

I print the USB Plug without supports. They have been printing just fine.

The Removal Tool is snug on the USB Plugs. I usually give each plug a slide of the tool. I print the tool with 5 USB Plugs usually. This allows the tool and plugs to get a little wear on them so they slide together pretty easily.