This is a quick-made mounting board that allows the DJI Phantom 03 flight controller to be easily installed in the fuselage of the TBS Caipi 2 wing. The controller is fixed to the DJI Phantom 03 using suitable-sized screws from the bottom - the original screws were too short, so I used the Apex Evo frame screws I had left over. The outer mounting holes are all standard M3 threaded holes. If you want to ensure that the screws can be screwed in deep enough, you may need to thicken the model appropriately

In order to provide a good heat dissipation effect for the 03, I chose TPU material for printing:https://www.thingiverse.com/thing:4673472/files

The opening size of this installation board is large enough for the 03 to pass through smoothly, ensuring air circulation while not requiring the cutting of the original hatch clips. Of course, you can also purchase additional clips from TBS and attach them with glue or epoxy resin, which will also work well. In my opinion, this type of clip design is more fitting and practical than the original foam hatch cover.

With the help of the printouts installed on the spacers, the connection of the USB data cable becomes extremely convenient, and the cable is located just above the surface of the wing; in addition, you can easily insert and remove the SD card in the cabin, which is very convenient to use.