I really liked the Raspberry Pi 3.5" TFT case, https://www.thingiverse.com/thing:1895374, but even with the clip the case wouldn't stay closed. Tape made it harder to get open and closed for future tinkering. Glue was just not something I wanted to do.

So I created these tight fitting case seals for the case. They fit on the top and the bottom, with a hole on the bottom to allow access to the microSD card, and do not block any ports or air vents. I printed them with 100% infill for maximum strength.

PowerSpec

Duplicator I3 PLUS

Yes

No

0.2

100%

My Powerspec Duplicator is cranky, you might be able to print without rafts.