PETG or ASA recommended for higher heat resistance.

Supports required

The two rear screws need to be shortened 2mm or buy some the same as the front. 

The clip can't be used

Use adaptive layers for best results on the curved surface

Note: This has been sized to fit the battery I installed with the electrical tape I wrapped around it, it's not a flush fit without it. Feel free to request alteration if needed.

The factory metal cover isn't glued, it only has adhesive, so use a heat gun to soften it.

I used isopropyl alcohol to loosen the adhesive on the battery, I made the mistake of tilting it forwards and the liquid ran through into the laser module, works still but looks bad. Don't do this.