Summary

This is a simple part for the latch of a truck bed canopy handle. Scale should be such that length is 60.5 mm

Fits standard sized canopy latches (8.5 x 8.5 mm square hole), uses a 3 mm plastic screw to secure. 52 mm from the center of the square post to the tip of the latch, 15 mm from where the web ends to the end of the latch.

Not as strong as the steel catch that comes with the truck, but, the reality is neither will stop a motivated thief from getting in!

I used no support, 50% infill, and draft settings, printed with a little less than 3m of filament in about 20 minutes.