Summary

A housing for an Ethernet Smooth Stepper

Max dimensions 6" X 7.5" X 2.5" (152.4mm X 190.5mm X 63.5mm)

Parts Required:

3 - DP25 D-Sub Connectors ribbon cable adapters + hardware (I made mine shorter)
1 - 1/2 hole strain relief
8 - 3mm screws

(Note I switch the Strain Relieve to the other side to give more clearance to the boards power plug)

(FYI if using a "CNC-step, Zero-3, 5_channel motor controller" LPT1 pin 16 needs a 12khz square wave applied to it, I used an arduino nano with the "Tone" it took me forever to figure that out)