A massively over engineered Hex piece holder (wall mounted) that can be built up on a carousel system. Knurl around the base so your fingers don't get too tired when selecting the hex piece you want. x 4 ball bearing holes (optional) so the carousel spins with minimal friction. this is completely unnecessary however it does make the end product feel ‘authentic’ as well as being a +1 masculine point… . All bases have a 5 degree tilt on the hex sections enabling you to remove them around 0.5 seconds quicker than had they been vertical.

The large base pieces are vertical as they could tilt too much, messing with my O.C.D.

Standard Base: Holds x 10 hex pieces, max height of pieces around 60mm

Extended Base: Holds x 20 hex pieces, max height of pieces around 50mm

Large Base: To hold ¼,3/8 & ½" socket-hex adapters & larger width things.

Large Base Extension piece: Adds 30mm height to above

Loads Base: Holds a lot of small hex bits

Main Holding Plate / Top Plate: Has 2 screw holes to mount onto a wall - typical 8 PZ screws are great. x 4 (8mm ball bearings) - totally optional. The top plate won't need ball bearings!.

Joining Base:  Has 2 screw holes to mount onto a wall - typical 8 PZ screws are great. x 4 (8mm ball bearings) - totally optional. x 2 support lugs to take the strain a little.

Printing settings: Print all pieces vertical. Supports needed. 3+ walls, 10%+ infill. 

Like, Share, Modify as you see fit. This item took 12 solid caffeine powered hours to design…

Size 9 shoe. UK based fat man.