This is a remix of the three hole key hanger by Hamsta1, which was originally remixed from the two hole version by borgchick, both here on Thingiverse.

I originally printed the three hole version for the lightswitch by my back door, but where it was going into was a new-to-us house and we had just repainted. It worked great, but I figured years of my keys whacking into my freshly re-done ( and currently somewhat soft ) paint would eventually show. So I added a shield so the keys could whack into that instead.
Keys could still slip off the side if in the first and last hangers. We don't have that many active key rings, so it's not an issue or we use it with smaller sets, but a re-remixing with a slightly wider shield ( not too big, this is close to the edge of my print volume ) might eventually happen when my print queue gets small enough. ;-)

Printed on an Ender 3 S1 Pro in white Overture PLA,, 20%infill, 220C hotend, 60C bed. No supports or adhesion needed ( look at all that surface! )

Creality

Ender 3 Pro

No

No

.2

20%