Logitech C920 case with support for 20x20x6mm heatsink (8 fins).

!!! Use extra electrical isolation on the back between the heatsink and the pcb to prevent short circuits (I used a 20x20x1mm non-electrically conductive thermal pad) !!!

Heatsink is 20x20x6mm heatsink (8 fins) and is press-fit into the base part. You can use taller heatsinks (6mm and 10mm are the most common heights I've seen) but they MUST be the type that has 8 rows of fins or else you won't be able to fit the heatsink properly.

Extended 1cm mounting point for standard 3d printed camera arm mounts that you can find elsewhere on this site and others.

This version screws into the base for aesthetic reasons. Use M3 10-14mm length screws. For me, 12mm was just right.