Summary

I wanted a box that she would actually use.

It's around 7 3/4" by 8" & 2" tall. You can modify it how you'd like.

I didn't include a lid, as one isn't desired, it's an open box.

I used red PLA, but you can use any filament & color you'd like.

It took 17+ hours to print at "regular", on my Kobra Max.

You can emboss or deboss something on the inside bottom, that's up to you. Ironing this, may cause issues, so be careful. I chose not to do that.

No supports are needed, as I printed it flat. I did use a skirt, because I like using them to make sure the last color is out of there, as best I can.

Good luck