Summary

This has gone thru quite a few R n D changes. I've uploaded two versions: Solid with no pass thru and the other one which seems to be the most desirable. There is enough room to set the phone in the stand up right and still be able to plug the charge cord in without having to bend the cord and with the pass thru 3/4" hole from the back you grab your phone and the cord will pull thru with ease so that you don't have to unplug the phone each time using it. The lip (Just tall enough to be able to hold the phone/tablet in place and still have full access to the lower section of your screen no matter which direction you choose to place the phone/tablet of the holder that holds the phone in place has 3/4" of space between the lip and the upright to be able to accommodate the various sizes of phones, protectors and tablets ( Some people I've printed this out for even use it for smaller books such as cooking recipe books to be able to hold the book open to that specific page. The dimensions (L x W x H) are 3.6" x 3.361" x 3.651" with a thickness of 0.2" has plenty of rigidity for tablets. I do use supports to help accommodate where the charge cord would pass thru both on the back side of the stand and where the phone would sit, I'd say that would be the most crucial for support is where the phone sits. I did this as a tutorial for "Freecad" Vogman with making quite a few changes as described above. I use the Creality K1 MAX that takes about 1 hour 25 min. I'll move this template into tinkercad and add that individuals name or business to it that I'm printing it for. I don't use supports for the lettering, but tree supports probably would come out near perfect where as the no supports still come out decent.