The original Eclipson Model Z motor mount is for outrunner motor, I design a motor mount for an inrunner motor.
You do not need the fuselage version with intake, as the motor mount is smaller and give more space for air to go around it.
This is the motor used on this mount:
https://hobbyking.com/fr_fr/turnigy-xk2845-1980kv-brushless-inrunner.html

Best print settings:
PLA: 2 p. layers, 3 bottom layers, 5 top, 0% infill expect on the screw holes part, set at 50%.
You can use dynamic infill.
I use 2x10mm screws to hold the mount to the fuselage.

You may have to cut 1mm of the nose of the plane depending of the offset between the motor and the prop.

Creality

Ender 3

No

Doesn't Matter

200

0-50%