A snap-fit mount designed specifically for the basic version of the Raspberry Pi camera. The mount is fixed to the installation board at the front of the Ender 5 printer with snap-fit fasteners, ensuring a good view of the bottom-layer printing details. At the same time, it is cleverly embedded inside the print frame, so even when the platform moves up and down, it won't obstruct the view. Since the installation position is far enough back, the original fan cover won't interfere with it either.

Due to slight deviations in the size of my printouts, even though the dimensions of all components were perfectly consistent, the printed parts were still a bit loose. For this reason, I had to slightly polish the snap arms to make them fit tightly against the body - if the size was too large, forcing them in would have torn the thin front wall of the body.

The face mask should fit snugly in place under pressure, but it can be quite difficult to remove it.