This is an enhancement for the LED light bar by Dooder_Snickel: https://www.thingiverse.com/thing:2765441 This lightbar for the CR-10S is a really nice design - but I have a CR-10 V2... This printer has additional braces for the Z axis, and the brackets on the top of the printer interfere with this lightbar. I could have shortened the lightbar, but it is sized exactly right for the 9.5mm LED strips. If you shorten the strips, you have to do it in three's, so that cuts 6 LEDs out. Rather than lose the light, I just made a spacer to lift the lightbar clear of the brackets. Another problem I had was that the adhesive on the LED strips did not stick well to the plastic, so I made caps to go over the LED strips to hold them in place. Everything should press together and hold with a friction fit.