This compact wall mount securely attaches your reTerminal E1001 & E1002 to any flat surface, freeing up desk space while keeping your device accessible and organized.

Key Benefits:

• Cable-Friendly Design: Avoids drilling a central hole, ideal for setups where central screw can't be drilled due to cable lines
• Anti-Rotation Stability: Features built-in tabs that prevent the device from twisting, ensuring it stays perfectly aligned once mounted.

Installation:

1. Select your mounting location, use the printed mount to mark the screws. Ideally do additional spirit leveling.
2. Drill pilot holes and secure the mount with wall screws (not included; suitable for drywall, wood, or masonry anchors). The hole size is 3.5-4~mm
3. Snap the reTerminal E1001 or E1002 onto the hook until it can't go any further, with top to bottom motion —it's tool-free and adjustable for a snug fit.

3D Printing Instructions:
Settings: Print in PLA or PETG (recommended) at 0.2mm layer height with supports enabled (use tree supports for efficiency).
Support Removal: Supports generate only between the mount base and hook for minimal cleanup. Once cooled, carefully trim them away using a flush cutter or fine hobby knife to avoid damaging the print.