Summary

Yet another spool holder!

For this one, it's a bit more convenient because you don't have to take any rods and adapters out of the center of your spool. You just align the wheels and place your spool on it, and away you go!

The rod for each side is 3D printable, but if you have a 5/6mm wooden dowel that would also fit. No need to glue the wheels on to the rods, as the spool would keep them in place, and so they can roll freely too.

There is also a wider base if you have a wider spool (like the Creality brand), and for that there is also a longer rod that you can print.

Infill for the base was 30% gyroid pattern.
The others I just kept at the default 20% infill.