This is an alternative battery holder for the Micro-RS4 1:18 scale rc-car chassis from HPI. It holds two 18650 cells.

You need to split the brackets in your slicer software

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2mm

Infill:

Filament: prusament, sometimes. PLA whatever you like Post-Printing =============

There are custom supports under those overhanging things that hold the thing onto the thing - you need to cut those out after printing.

There are alignment holes - put some nails through those while you superglue the brackety things onto the platey thing. I ground the surfaces to be glued flat using some sandpaper, helps with adhesion. Also, don't be an idiot and create short circuits, those cells can get real hot real fast and set your house on fire and stuff.

How I Designed This

I used blender. I know it is not ideal, but i know it well - you know what they say about hammers and nails. Well, blender is my hammer.

Category: R/C Vehicles