This mount for the Hemera requires a stand alone X-Axis Tensioner (Included) that is not connected to the mounting bracket. I have the Y-version of this available as well, just check my other Things. Both the X and Y Tensioners require a ball end hex wrench to adjust the tension. I've also designed adapters for the Diii and Ciii coolers (D/Ciii coolers designed by Pawpawpaw85). For the Diii there are two versions depending on how close you want the cooler from the Bed.

Please note that the Hemera bracket is designed to use M3 washers with the four M3x8mm screws that mount the stepper motor which should result in the screw coming just to the end of the nut. If you do not use the washer you must make sure that the screw will not bottom out in the stepper motor housing.

Enjoy!

Required Fasteners:

Mount to the X-Carrage:

• Six M4x8mm

Stepper Motor to Bracket:

• Four M3x8mm w/M3 washers

Limit Switch:

• Two M2x10mm
• Two M2 Nuts

X-Axis Tensioner:

• Belt Pins: Two M4x16mm (if you want to use a nylock nut then use an M4x18mm)
• Mounting Bolts: Two M4x12mm
• Button head Hex M3x16mm, Two M3 washers and one M3 nylock nut

Print Settings

Printer Brand:

PowerSpec

Printer:

Rafts:

No

Supports:

Resolution:

0.3

Infill:

Filament: Polymaker PETG

Notes:

Category: 3D Printer Parts