A knife holder designed specifically for the Camelie razor with a round handle. If the print parameters are set properly, you can easily pick up and put down the razor with just one hand, without needing to hold it with your other hand, and it can also ensure that the razor is firmly in place. The knife holder is also compatible with other razors of similar size and design.

Printing with PLA material, the layer height is set to 0.15mm, the first layer height is 0.22mm, the infill density is 10%, the printing speed is 80mm/s, and the total printing time is about 35 minutes.

The bottom of the knife holder is equipped with a conical drainage hole, which effectively prevents water from stagnating after use. Since the razor needs to be placed upright, it is recommended to use it only on a flat and stable surface.
Note: The long-term performance of the product in bathroom environments and high humidity conditions is still under testing.