Project: lion1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 297.5x300mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.16mm

Filaments Used:
#080a0d PLA PolyLite Black  Transmission Distance: 0.3
#56b7e6 PLA BambuLab Matte Sky Blue  Transmission Distance: 1.3
#0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 3.5
#c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
#cd007b PLA BambuLab Basic Magenta  Transmission Distance: 3
#fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
#ff9016 PLA BambuLab Basic Pumpkin Orange  Transmission Distance: 5.5
#00ae42 PLA BambuLab Basic BambuLab Green  Transmission Distance: 2
#e2dedb PLA PolyLite White  Transmission Distance: 5
This print uses 9 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Sky Blue
At layer #11 (0.96mm) swap to Cyan
At layer #13 (1.12mm) swap to Red
WARNING: This Slider is at the same Layer as the Next Slider
At layer #16 (1.36mm) swap to Magenta
At layer #16 (1.36mm) swap to Yellow
At layer #18 (1.52mm) swap to Pumpkin Orange
At layer #19 (1.6mm) swap to BambuLab Green
At layer #21 (1.76mm) swap to White for the rest.