I wanted a stand to raise my laptop to a high angle, and I was unhappy with how heavy most models on the internet are. Therefore, I created this model with lots of hexagons and very little mass. Each of the end pieces weighs just about 20g, and including the crossbar the whole stand comes out at around 45g - a fraction of most other models!

The stand raises my laptop to a 60-degree angle, so only print this if your laptop has a hinge which goes that far. The model is made to fit laptops with a base of at most 15 mm. The crossbar is optional and it is quite stable even without. If the crossbar is used, it fixes the two legs at a distance of 139 mm measured from the inside of legs.