Lost button on my cycle computer Sigma 906 (sold also branded as Force F9) so had to replace it.

Model is top right button for counter resetting, for top left one just mirror the file appropriately.

This is second revision which is, for me, good enough. As seen on photo it don't exactly match with original button, but will work on it if needed replace it again.

Source file included, feel free to fix it.

Print Settings

Printer:

Prusa i3 plus original kit

Rafts:

No

Resolution:

100 %

Notes:

Printed from Fillamentum FlexFill 98A TPE filament. Manual part cooling fan on low intensity for sharp column needed.

Post-Printing

Need to cut ridge on top edge which grabs to frame. Used thin dremel cut wheel for it. Small hand file should also work well. Be careful if using knife.

This was designed intentionally as supporting such a small gap will end in almost same result.