This is a Commodore 64 or 128 userport case. Designed specifically for use with the Strikelink modem but should be usable for other devices. Designed to accommodate cards up to 1-3/4" wide (edge to edge on the connector pins) and 2-3/4" long. Userport connector holder integrated into the design so no screws for the connector are required. Case can be fastened with two M3 pan head machine screws.

Recommended print settings are 55 degree overhang, 25% support infill, zigzag pattern, support roof enabled for a clean overhang. Same for the screw holes on the bottom. If your printer is well calibrated the supports should come off with minimal effort.

Anycubic

Kobra

No

Yes

.2

15%