I was adding my new registration renewal to the motorcycle and had the toolkit out. There were a couple of small sizes of sockets I wanted to add to the kit and noticed how they fit nicely in the tape roll. Hmmm, maybe I could make a little box to hold them. So, measure, design in TinkerCad, and print in 15 minutes (Ludicrous mode!) The entire project done in less than an hour.

I doubt many people will find this particular model useful, but might be inspired to use their 3D printer for minor everyday tasks, and beginners can see just how easy it really is to make useful stuff.

(Printed with eSUN PLA+ on a Bambu Labs P1P, in yes, "Ludicrous Mode".)