This model will adapt a Honey Bee AT Switch by Adaptivations to 1/4"-20 camera mounts. The Honey Bee is a proximity switch that uses IR to sense motion. See page 7 of this catalog for more information: http://media.wix.com/ugd/b1a4c2_1ff6103f173d4174a58c9d779eabfc0f.pdf

This file is part of our collection of AT Switch adapters. Learn more at: http://atmakers.org/2017/02/at-switch-adapters/

Note that there are separate STLs for the various TNuts: this allows for 3/4/6 pronged TNuts in 5/16, 7/16, and 9/16 lengths

Please join us at https://www.facebook.com/groups/ATMakers/ as we develop this collection.

Print Settings

Printer Brand:

FlashForge

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.20 mm

Infill:

Notes:

This prints great vertically, but will require supports for the 1/4-20 hole (which must be accurate.

I have only tested this with PLA at this point and would appreciate any feedback.

How I Designed This

The Fusion 360 model is attached. If you want to collaborate on the official version, please contact us.

To adjust the TNut length, simple undo the last two extrusions (roll back the timeline) as that adjust the depth. (Steps are named "Shrink to 7/16" etc.)

Category: Other