Summary

One of the better grinders I’ve owned but, the minimal gripping features (for removing the tray and lid) needed improvement…

Fits Capresso “570.1 Infinity Plus” and, perhaps similar models (probably common parts shared across models).

As with all printed parts, printers, processes and materials have varying results of shrinking - I’ve printed these in PLA and PETG. Scale the parts a fractional percentage, if needed...

The Lid: ---------------------------------------------------------------

There is a Recess Pocket for the Capresso’s lid - Press it into the LidHandle part - it may need a bit of force to ‘Pop’ it in (and pop out to remove).
(Once placed, it will freely rotate inside the handle)

The TrayGrip: -------------------------------------------------------

Slide Down onto the tray from top (ensure edges are in the slots). Press on until the bottom of Grip and Tray are even.

Printing: ---------------------------------------------------------------

If printing in orientation as shown, you may need supports as shown (depends on Printer and Process...).

No supports needed in LidHandle or TrayGrip's groves/slots - more difficult to clean than benefits gained... )

Note:

Parts in photo's are as-printed - not sanded, painted or prettied up for posting or my use