In the process of water cooling my PC, Lancool II Mesh case, I struggled with where I wanted my pump/reservoir combo. I needed to get the pump closer to the fan for clearances, so I designed what I needed. All that is needed is 8 chassis fan screws. The pump mount installs to the bottom of the fan mounts (print 2). You will need a 90 degree bit driver or a carefully use a long screw driver to install two of the fan mount screws.

Print the fan mounts flat with the pump mount. No support should be needed.

*Once I have my full loop complete and installed, I'll update with pictures of the bracket installed.

UPDATE: Attached photo of installed bracket, due to height spacing, I installed the bracket on top of the fan side bracket instead of how it was configured in the 3D model example. The bracket has been in my PC for a few weeks, works perfectly.

Anycubic

Kobra

No

No

.2mm

100%