Caps for the Begode MTEN4 EUC.

The button-side one is designed to stay in place. The pin in the middle makes it possible to press on the cap to use the power switch with the cap in place.

The charging port-side one does not have a pin in the middle.

I advise to print them with TPU that is below 90A tough. I designed two thinner versions that can be printed with TPU 90 + but it is less usable and harder to install.

Artillery

Artillery Sidewinder X1

No

Yes

0.32

If you don't have TPU with toughness < 90, use files with 95 in their name. The cap is slightly thiner for a better bending.

I printed them with filaflex 82A on a sidewinder X2.

• Temp 235 C
• flow 115%
• speed 40 mm/s
• fan speed 15%