Remixed multi-sensor box based on https://www.thingiverse.com/thing:5516089. This goes with the walk through & video by ResinChem Tech https://resinchemtech.blogspot.com/2022/10/a-new-multisensor.html

Note this box is built to mount an ElectroCookie prototype board https://www.amazon.com/dp/B07ZYNWJ1S

I designed this with Fusion 360, the lid was imported and tweaked, the box was built from scratch based on ResinChem Tech's box.

I have included the .step files if you wish to make further tweaks to the box to fit your project.

I printed this on a resin printer, but should do just fine with no supports on an FDM printer.

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

No

Supports:

Resolution:

.05mm layers

Infill:

Filament: Siraya Tech Fast ABS like White

Notes:

Category: Electronics