My printer (Hictop i3) came with a mount for the Z-axis endstop made out of two acrylic pieces. Of course, it doesn't need adjusted all that often...but, when it does, I found it a bit frustrating that it requires a wrench or needlenose pliers awkwardly jammed behind the leadscrew to hold the tiny M3 and M2 nuts while adjusting.

This is a printable replacement with a few improvements:

• Captive nuts for both the limit switch screws and mounting screws
• Pins that mate into the adjustment slot for easier positioning without side-to-side movement.
• Mount is one solid piece

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Notes:

Recommend printing at 100% infill for structural durability but it's not critical. I printed at 0.2mm layer height for appearance but 0.3mm would also be fine.

Category: 3D Printer Parts